Samsung Refrigerator Ice Maker Not Working But Water Does

I bought my refrigerator 2 days ago.

Samsung refrigerator ice maker not working but water does.

The valve requires at least 20 psi to function properly. I hear a clicking sound when i believe it is trying to drop the ice into the bucket. 32 hours later no ice has been made. However there is a facebook group of more than 6 400 members calling.

In the event of a frozen ice bucket some troubleshooting may be needed and service may be required. Save hundreds of so do this before you call for service. It was plugged in and set the freezer to 0 degrees. I have a samsung rf28hmedbsr the ice maker has stopped working.

The valve requires at least 20p si to function properly. I have reset the ice maker and defrosted the ice maker. I turned it off for a little over a week then turned it back on. There are a few factors that can cause an ice maker to not work.

Samsung ice maker not working. Samsung says the water line within the freezer door can freeze. It dropped one tray of ice then nothing more and the still hear the clicking. Make sure that the water pressure to the valve is at least 20 psi.

Approximately 10 ours later there s still no ice made. The water inlet valve is an electrically controlled valve that opens to supply water to the dispenser and ice maker. If the ice maker appears to not be making any or enough ice low water pressure or a faulty water filter may be to blame. Last night i set it 1 degrees and hit the reset button.

As a result the ice maker won t make ice. How to reset ice maker for samsung refrigerator french door. The water filter is located in one of the two places below in your refrigerator. Currently samsung does not have a recall in place for any of its refrigerator models when it comes to the ice maker issue.

Samsung states to check the orange water line at the front bottom of the refrigerator and see if the water line is frozen. Water pressure is good. The water inlet valve opens to supply water to the dispenser. If the water filter is not correctly installed it can block the water flow into the dispenser.

If the water inlet valve is defective or if the water pressure is too low the water valve will not open. My water comes out fine so i m assuming it s not the water l.